The conventional way of sandblasting is to make a template using a vinyl cutter  by cutting vinyl in the shape that you want to blast, then ‘weeding’ out the vinyl where you want to blast, sticking it onto the item to be blasted, and blasting away with sand which eats the areas not covered with vinyl. With conventional sandblasting, It’s impossible to blast very fine detail and photographs.
See Some Examples



With our Photobasting system:
You can Sandblast anything, irrespective of the complexity of the logo. Photographic and 3-D blasting is the easiest thing in the world to do. All the equipment is portable, and can even be run off a gas bottle, so you can travel with it. Anything created on the computer can be blasted, no matter how complex – even photo’s.

How does our system work?
It’s actually quite simple. You create your artwork on the computer, and print it out onto a type of “tracing paper”. You then take this paper, and put it against the Photosensitive masking film (also called a Photomask) and expose it in the exposure unit for a minute or so. Then you take the photomask and wash it out with our spray jet. Wherever there was black print on your “tracing paper” it prevented the light from getting to the mask and hardening it, so those areas wash out with the water. You then let the mask dry, and apply it to the item to be blasted, and you blast away.

The Photoblast system includes:
The blast wand & pressure pot
Air regulator, and water trap
Blast cabinet with extractor fan
Air / Sand Mixture adjustment
Dextralite UV Exposure unit
High pressure sprayjet
Pack of Photomasks and Vellum
Pack of Adhesive
Training by a blast professional

Optional Extras:
Photomask (per 25cm x 30cm sheet) ………………………………………. Call
Vellum for use in a laser printer (per sheet) ………………………………… Call
Enhancing Liquid (per bottle) …………………………………………………. Call
Sand (25Kg, 220Grit) ………………………………………………………….. Call
Personalised Advanced Training Course ……………………………………. Call

Copyright © 2007 by JG-Electronics All rights reserved.